RFID multiplexers: AdvanMux-16TM 

advanmux-16         AdvanMux-16-with-enclosure

 

 

 

 

AdvanMux-16 is a high performance 16 port multiplexer that expands by a factor 16 the number of antennas that can be connected to each port of an RFID reader.

AdvanMux-16 is easy to connect to practically every RFID reader in the market, including Impinj, Sirit, Motorola, ThingMagic Mercury6, and others.

AdvanMux-16 is connected to the I/O port of most reader models, and it is controlled by sending simple commands to the reader. This facilitates a lot the control of AdvanMux-16 and its synchronization with the reader. Any port of AdvanMux-16 can be selected at any time.

Business benefits of AdvanMux-16:

  • Reduces the cost of RFID applications with many antennas
  • Very fast and easy connection
  • Compatible with most reader models
  • Easy selection of ports by sending proper commands to the reader
  • Easy control of several  multiplexers by interconnecting them with standard Ethernet cables
  • Low insertion loss

Download AdvanMux-16 data sheet   

Specifications:

Operating frequency 860 MHz to 950 MHz
Number of ports 16
Insertion loss 1.2 dB (typ.)
Isolation 30 dB (typ.)
Return loss 20 dB (typ.), 16 dB (min.)
Max input power 33 dBm
Switching time < 10 µs
RF connectors 1 input and 16 output SMA 50 ohm receptacle connectors
Control and power connector 2 input/output RJ45 connectors
Power supply Pin 4 and/or Pin 5: Vcc = 5 V to 48 V
Current consumption < 11 mA
Digital inputs 0 V/5 V TTL or open collector
Note: Reader outputs must sink 2 mA (maximum)
Connection to AdvanReader-100 and AdvanReader-150 Requires only a conventional Ethernet cable
AdvanReader allows using two-level AdvanMux-16 multiplexing, so that up to 1024 antennas can be connected to the same reader
Connection to Impinj R220 and R420, and ThingMagic Mercury 6 Requires a cable adapter (available upon request) and a conventional Ethernet cable (UTP cable)
Connection to other readers Compatibility with most readers. Requirements:
– AdvanGPIO connection board (available upon request)
– For some reader models: PoE injector (available upon request)
Cable adapter Optional
Length: 25 centimetres (10 inches)
Control connection between AdvanMux units Through standard Ethernet 8-wire UTP cables
Electrostatic protection Included for all RF input/outputs